Environmentally friendly Artificial Lawn in Fawn Creek Regardless of whether you live in a drought-plagued region or not, our professionals Synthetic Lawn can save you money while keeping your yard looking beautiful. Since our fake grass requires no maintenance from gas or electric-powered grass lawn equipment, our company Synthetic Lawn is more eco-friendly than even natural grass, specially in Fawn Creek. With global warming, water restrictions are often applied in an attempt to save the precious liquid. These restrictions can be devastating for real grass lawns, actually destroying them completely in some cases. Healthy, lush appearance, all year round Synthetic Turf in Fawn Creek Since Artificial Turf needs no water at all to survive, these restrictions have no effect on it at all, and Synthetic Turf in Fawn Creek, Kansas will stay nice and fresh-looking all through the year. The Synthetic Turf in Fawn Creek you purchase from us, means that you will have a great, lush looking lawn all through the year, no matter what the month. I added a USB drive with a 512MB SWAP and 59GB EXT3 Partition label jffs.īut I didn't make directory /jffs/etc/config/ There are four different directories DD-WRT searches for scripts, these are The CIFS Automount looked to be for LAN drives. You need to add an extension to the script if placed in one of the previous folders. startup will be executed on system startup, normally boot-time and before the firewall is configured. prewall will be executed whenever the WAN interface goes up and before the firewall. wanup will be executed whenever the WAN interface goes up and after the firewall. (no longer in source code, must be deleted) if will be executed whenever any interface goes up and after the firewall. ipup is run when PPP connection is reestablished after a disconnect and after the firewall. sesbutton is executed when the SES/AOSS/EZ-SETUP button is pressed (no longer in source code, must be deleted?) ipdown is run when a PPP connection has been shut down. So why not just place a script in the /jffs/etc/config/ directory that is read on boot. Kill for /usr/sbin/smbd -D -configfile=/tmp/smb.conf usr/sbin/nmbd -D -configfile=/tmp/smb.conf If this would work, I need just need to know what the script needs to look like. usr/sbin/smbd -D -configfile=/tmp/smb.confĭoing samba -> enable -> disable -> apply.ģ786 root 2476 S /usr/sbin/smbd -D -configfile=/tmp/smb.confģ788 root 2304 S /usr/sbin/nmbd -D -configfile=/tmp/smb.confĤ024 root 2476 S /usr/sbin/smbd -D -configfile=/tmp/smb.confĤ047 root 2304 S /usr/sbin/nmbd -D -configfile=/tmp/smb.confīoth started up. Ok my commands to start samba were right but something is keeping nmbd from starting. I killed both processes and restarted them and the samba share was up.
0 Comments
Leave a Reply. |